Jump to content

Vehicle Tracking seperate turning of rear axles


OMEGA-ThundeR

Recommended Posts

Hi,

 

In below picture on the left is the steering of the axels the way i need them to react, on the right is my custom design in Autodesk Vehicle Tracking

 

steering.jpg

 

I can't seem to find a way to make the 3 rear axles turn on seperate ways. They all go at once or not at all.

 

Any idea what kind of setting i must change to get the same result as on the left vehicle?

 

The first of the 3 needs to steer is the same direction as the front axle, the middle needs to be fixed and the last in an opposite direction to the front and first axle.

 

Edit: I'm not sure if it would make any difference other than aesthetics though...

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...