Jump to content

Move Model Space to Layout 1 Tab


Casio47

Recommended Posts

  • Replies 21
  • Created
  • Last Reply

Top Posters In This Topic

  • Casio47

    5

  • ReMark

    4

  • OMEGA-ThundeR

    3

  • rkmcswain

    2

So I have a factory floor layout file. There are 3 future state concepts with each concept having multiple variations and a new set of dimensions for each variation. There are 16 variations as of now (including dimensions for each variation). To organize, I put each variation on a separate ...

 

This sound like you are not familiar with XREF. Try that, read about it..

Make the variations based on a the basic THREE designconcept fles as origin, then different layouts (Viewports ring a bell?) and layers LATER ON will lead to desired 16 paperspaces (aka drawings). My advice, Good luck ;-)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...