Jump to content

Nevermind...sorry, figured it out.


HCb

Recommended Posts

Well, I figured it out...like all too often happens, I don't give up even after asking a question and then stumble on the problem. The second sketch wasn't locked to the vertical axis even though I thought it was. Sorry for the trouble.

 

Thank you.

 

--HCDropPiece.ipt

Edited by HCb
Figured it out.
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...