Jump to content

Need help turning this into a solid


wezzo18

Recommended Posts

Is it an angle with the ends chopped or is it hollow ? Just start with extruding that shape then make other shapes and "Subtract" if hollow it still has a wall thickness, use press pull.

ScreenShot018.jpg

Edited by BIGAL
Link to comment
Share on other sites

I think the OP extruded a bunch of lines and ended up with surfaces as opposed to extruding a single continuous polyline profile or using PRESSPULL.

 

 

wezzo: Here is sample drawing illustrating the difference between extruding a group of lines versus a single continuous polyline. The drawing was saved in 2010 file format so you should have no trouble opening it.

Sample extrusions.dwg

Edited by ReMark
Link to comment
Share on other sites

  • 5 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...