Jump to content

Co-worker CAD rant


f700es

Recommended Posts

FML! I was updating some department boundaries today for a financial report. Some of the boundries that were put in by a coworker needed to be edited and I kept getting non-complainer errors on the existing plines. I selected the existing plines and looked in the properties window and it said it was "0". So on a hunch I upped the units to 1/256" and then checked them again....JFC!

 

Screenshot_2.jpg

 

Elevation = "-13/256"

 

I just don't know you even do that.

Link to comment
Share on other sites

Either ELEVATION = non-zero -or- someone took a non-zero elevation polyline and used is as their template for all others (copying it around).

Other than that, it would take some work and maliciousness.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...