Donni123 Posted September 21, 2017 Share Posted September 21, 2017 Hello, I wrote a macro for automatically userdefined hole in a sketch. In this macro I set the tolerance for diameter and depth. The macro works fine for that, but if I use "Show Dimension" the tolerance is wrong. I checked that the macro sets the right parameters. Only if I manually open the "Dimension properties...", open something (e.g. dropdownlist) and close the dialog, the correct tolerance will be shown. Has anybody an idea or solution to fix this problem. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.