ankurpraja Posted September 27, 2017 Share Posted September 27, 2017 Adaptive Gusset.ipt Hi All, Attached is the adaptive part i made in Inventor 2018. This is used for I-Beams and Channels. There are no constrains in the sketch so that when i constrain the part in the assembly, it will adapt the size of that beam. This all works fine except that the sketch will not remain at the origin. I would like to use the origin planes to constrain for other occurrences in the assembly. And if i constrain the sketch to the origin then the part will not be adaptive in the assembly. Any solution for above? I don't want to add new planes. Thanks. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.