Jump to content

Adaptive Part


ankurpraja

Recommended Posts

Adaptive Gusset.ipt

 

Hi All,

Attached is the adaptive part i made in Inventor 2018. This is used for I-Beams and Channels. There are no constrains in the sketch so that when i constrain the part in the assembly, it will adapt the size of that beam.

 

This all works fine except that the sketch will not remain at the origin. I would like to use the origin planes to constrain for other occurrences in the assembly. And if i constrain the sketch to the origin then the part will not be adaptive in the assembly.

 

Any solution for above? I don't want to add new planes.

Thanks.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...