Jump to content

Cannot see Model drawing in Layout


PJ01

Recommended Posts

Hello, as a raw newbie, I have made a 100 x 200mm rectangle on my Model tab, and on the Layout tab, have prepared an A4 sheet, with border and Vport and Title block.

However, the drawing does not show up on my Layout

 

Can anyone please advise any steps I may have missed?

Link to comment
Share on other sites

Welcome to CADTutor PJ01. :)

 

Double click into your Viewport, then Zoom Extents.

 

Whoops, ReMark to the rescue. :beer:

Edited by Dadgad
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...