Jump to content

Roundup a data extraction, how?


halam

Recommended Posts

Hi all,

I can make dataextraction on mass objects.

These objects are converted 3D solids to masses (not blocks!)

I notice that there are very, very little difference in the Volume calulations that make then unique. Which i don't want off course.

 

 

So, my question is this..

Is there a way to data some kind of round off BEFORE dataextraction..

See attached

dataextraction op basis van volume.jpg

cause of making it unique.JPG

Edited by halam
Extra screenshot to clarify
Link to comment
Share on other sites

Not yet. I was trying to get this under the attention of Autodesk. That is even harder since there is no 'ideas for AutoCAD' to begin with.. :x

Link to comment
Share on other sites

H try .... right clicking on the column name you want to change ... it will say column format. Click on decimal and then it will say current precision. Click on that and it should change it for you. Once you do that make a copy of the dxe and use that as your template next time you have to do that extraction.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...