Jump to content

Using visibility states


Jman

Recommended Posts

I've been toying with this feature for a while and I must say it has saved

me a lot of time. I have posted one of my dynamic casework blocks below.

It is actually 4 individual pieces of casework in one block. Reason being is

i have Handicap Accessible heights to deal with. Adult counter top height is

34"max. Elementary 29" max. and kindergarten/preschool is 24" max. Plus

standard adult height which is 36" max. My problem here was the shelving

arrangement. Because my casework is not all even dimensions, I couldn't use

the stretch command and get even spacing. So i created one piece of casework

and then set up 3 other visibility states. With each state I hid the previous

cabinet and inserted another cabinet and so on. I also had to make a visual

state for back splashes as on a wet wall or one that has a sink, i needed to

have them. on others, i was able to turn them off I also had to do this for

some dimensions as I also arrayed the casework and sometimes i don't

need the overall dim to be there if only one cabinet is used. I'm sure there

may be faster ways to do this but this one worked for me and I was able to

eliminate single blocks out of my library making more space on the network

drive. Anyway, I hope you like it.

180 - 36x24.dwg

Edited by Jman
grammer
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...