Jump to content

wblock and ucs


chrisdarmanin

Recommended Posts

help as this is driving me crazy I export part of a drawing with wblock and set the basepoint such as the lift shaft. then I start a new drawing and insert the exported block as xref. The UCS 0,0 is not as the basepoint as I specified when I exported with wblock. Am I missing something? I need the basepoint to insert at 0,0

Link to comment
Share on other sites

Have you checked the INSBASE variable in the destination drawing? Have you opened the WBLOCKed drawing and verified the base point?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...