Jump to content

Pipe Route from weldolet


ankurpraja

Recommended Posts

Weldolet.jpg

 

Hello everyone, Happy New Year,

I am modelling a manifold and stuck at a point where I need to route a pipe from weldolet. Ideally I would place the weldolet on the main header and start the route from the butt weld end of the weldolet. But in my case I already have the butt weld end connected to the gate valve. Now i need the start the pipe route from the other end of the weldolet. See the picture.

 

Is there any possibility to do this?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...