Jump to content

Hole table question


andar424

Recommended Posts

So I have an auxiliary view on a print that I have a ordinate set of dimensions on that do not match the coordinates of the holes in a hole table. I was having trouble at first trying to get the ordinate dimensions to align with the view, but figured that out. Now, when I add a hole table in, the dimensions don't correspond to the correct coordinates. I want the origin at the top left corner of my view then aligned to the auxiliary view angle, and then I want the hole table to use those dimensions generated from that origin. Is there something I'm missing?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...