Jump to content

Dynamic block for a section marker


raj banerjee

Recommended Posts

Hello peeps,

Im a bit stuck, I have a section marker dynamic block I have created. Basically it consists of a circle, with the section ref at the top of the circle, a line from left quadrant to right quadrant and the drawing number at the bottom of the circle. This marker appears at both ends of the section marker, there is a rotation function and also a stretch function to allow the gap between the 2 circles bigger.

 

Here is where I get stuck, I can make the text and separator line stay horizontal no matter the rotation as the base point of rotation is the centre of the circle, but for the other end I cannot figure hour how to keep that info horizontal?

 

Any suggestions would be great

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...