Jump to content

How to Draw Dimetric Cube?


Recommended Posts

I think that you would have better information by searching on the web.

 

I googled it, and found this site full of most excellent information on Axonometric projections.

 

Nicely done eldon, a wealth of information on that link! :beer:

Link to comment
Share on other sites

It would have looked better to have reduced the lengths of the red and green faces, to about half of the width of the blue face, rather than doubling them, if this is meant to represent a cube. :)

Link to comment
Share on other sites

I think that you would have better information by searching on the web.

 

I googled it, and found this site full of most excellent information on Axonometric projections.

 

I read in your above link about dimetric.

 

It doesn't show how to draw a dimetric cube.

 

Can someone show me how to draw dimetric by a projection method?

Link to comment
Share on other sites

..........It doesn't show how to draw a dimetric cube......

 

Really???

 

There was a welter of information. Perhaps you did not read far enough. It will never say "Start the line command" and "Draw a line". You have to interpret the information and draw it for yourself.

 

This is part of the information. I am sure that plenty of folk here could make a good fist at drawing a Dimetric Cube.

DimetricProjection.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...