Bogbadbob658 Posted February 5, 2018 Share Posted February 5, 2018 I have block (I didn't create it) which gives the xy co-ords of the insertion point but the precision is only to 2 decimal places and I need it to 3. How do I change it? I need it in a step by step answer as I don't really understand the attribute thing. Thanks in advance. Drawing3.dwg Quote Link to comment Share on other sites More sharing options...
iconeo Posted February 5, 2018 Share Posted February 5, 2018 Go into attribute editor. Double click on the grey field. In the Field editor on the right hand side you will see the precision for the units. Quote Link to comment Share on other sites More sharing options...
BIGAL Posted February 6, 2018 Share Posted February 6, 2018 A little bit more at the start Command: EATTEDIT Select a block: Quote Link to comment Share on other sites More sharing options...
Bogbadbob658 Posted February 6, 2018 Author Share Posted February 6, 2018 Thank you. I wasted hours yesterday trying to work this out. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.