Jump to content

Block insertion point changed after using lisp


DGRL

Recommended Posts

Dear forum members,

 

 

I have a lisp that changed MTEXT into ATTRIBS but for some reason the insertion point of the block Is changed from original point to the insertion point of last added ATTRIBUTE

 

 

Does any of you know a way to set the block insertion point to desired coordinates?

 

 

And this must be done using lisp only

It is because I need to change more then 750 dwg's lol

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...