Jump to content

generic materials to 3d solids


svizoman

Recommended Posts

I wish to apply new generic material from google map satelite image to a 3d solid.

 

The 3d soild (dimension 300m x 150m x 0.1m) will represent the land and will have a cut out of 10m x 14m - where the 3d building will be placed.

 

First I made a printcreen of google satelite photo. I've cut the image to be in the ratio of 2.5 to 1.5.

Then I created the box of 300m x 150m x 0.1m.

Then I created new generic material of the google satelite image. I changed the size of the material image to 300.000 x 150.000

I applied new material to the box.

 

Problems:

1. when i made the cut out to the box, material is all messed up

2. although google satelite image (jpg) is of good quality, quality in acad is poor (image quality is set to high)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...