miroslav_s Posted March 29, 2018 Share Posted March 29, 2018 hello, where or more like HOW can I change the thickness of my slab so that on side is smaller then the other side. Like this: http://prntscr.com/iy69m0 thanks in advance, best regards, Miro Quote Link to comment Share on other sites More sharing options...
welldriller Posted March 30, 2018 Share Posted March 30, 2018 1 way (yes it's time consuming) draw the bottom horizontal base line. Then draw the vertical lines on each end the height you want. Then draw the top horizontal line. Bingo big on one end smaller on the other. Quote Link to comment Share on other sites More sharing options...
danellis Posted March 30, 2018 Share Posted March 30, 2018 You might be able to use a Body Modifier? dJE Quote Link to comment Share on other sites More sharing options...
miroslav_s Posted March 30, 2018 Author Share Posted March 30, 2018 You might be able to use a Body Modifier? dJE Yepp you are right Thanks Miro Quote Link to comment Share on other sites More sharing options...
miroslav_s Posted July 15, 2018 Author Share Posted July 15, 2018 1 way (yes it's time consuming) draw the bottom horizontal base line. Then draw the vertical lines on each end the height you want. Then draw the top horizontal line. Bingo big on one end smaller on the other. I was more thinking about slabs in Autocad Architecture....so thank you but NO that was not the answer I was hoping for. Your solution dont help at all. Thanks anyway Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.