Siberian Posted June 8, 2018 Share Posted June 8, 2018 Where I'm from elbows and tees in a pipe run are typically displayed without the lines at each connection shown in the picture so that an elbow would only look like an arc. I know I can edit the family files and remove them, but that is a somewhat tedious task. Is there any simpler way of achieving this? Quote Link to comment Share on other sites More sharing options...
tzframpton Posted June 8, 2018 Share Posted June 8, 2018 It's not that tedious. I removed the lines 8 years ago. Doing it once, it's done for good. I also took out the arc... mitered all the way. Our single line piping plans look great. -TZ Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.