Jump to content

.ipt part not showing up in Drawing file from model


DiamondZ

Recommended Posts

Hello,

I have several models of dispenser sumps that I am working on, and there is one specific piece (a shear valve) that is very clearly in the model, however, when I place the assembly in a standard.dwg or standard.idw, the shear valve does not show up. Alternatively, when I place just the single part in a .dwg or .idw, the valve shows up perfectly. I researched the solution and found that it could be as simple as choosing the "Include All Surfaces" option on the drop down menu, however, I can not find that option on my drop down. It is not greyed out, it just doesn't show up. The valve is used in about 20 different places on this project and entire assemblies are surrounding this part! Please help!

 

Thank you

 

Rachel

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...