help with dynamic block

[PjotrVk]

I tried to make a dynamic block. I'm on a brink of giving up and start learning lisp.
I need this product stretched without changing the angel of the diagonal line.

Can anybody help?

Muchos grasias

[fuccaro]

bracket.dwg
Welcome in the forum!

[PjotrVk]

I should have come here earlier.
I still have to find out wat you have done, but that's a nice trick.

It's a little bit more complicated than this. I attached an other file. I hope its a little more clear. Sorry for that.

[chulse]

does it need to have infinite adjustment or only a few known dimension sets?

[chulse]

Is this better?

I'm still learning these too...

[PjotrVk]

It needs to be no wider than 130mm (extually 120, but this is just to be safe) and no smaller than 35mm
The constuction could be 1500mm high.

The left vertical line needs a minimal of 50mm. but this is more than hope to get with Dynamic blocks. This is more a lisp thing. When I have time between school and work i'll work on it.

[hazardman]

this is fairly close to what you want!...so go ahead and do some reverse engineering on it...of note is the stretch parameter that does the 45 degree angle...i used a multiplier of 1.41421356 (squareroot of 2 as it's the hypothenus (sp?)) to keep it lined up with the left side as it stretches...


enjoy!

[Mr Cory]

Grrr you bet me to it Hazardman, darn people interupting me

[PjotrVk]

Wow... hazardman. Thanks you solved it. I also was playing with
√2 but I couldn't get it right.

Everyone thanks for trying.

Now I have to find out how it works.

[PjotrVk]

I will show you a more complete block, just because you guys helped me so well

Products of my company:
http://www.batcontinental.nl/Uploads/10060_MO.jpg