Plot Preview and Off Centre Plots

[danj0nes]

When I go in to paper space I normally see a preview of the drawing and its paper, now all I get is a white back ground with a my drawing template in the middle? When I plot I have to now use the pick window and centre plot commands.

Anyone had similar problems??

Dan

[Skeeps]

When you go to page setup and pick what you want does it still show the preview incorrectly?
I've had no end of problems printing. I must be the worlds worst person for wasting paper.
Is this on old drawings? Or new drawings you have recently created?
There is a way you can create page setups and import them in at the begining of your drawing by going to plot then where it states 'page setup name ' click to add.
Not sure if this helps,
but have a merry christmas anyway.

[DoYouKnowMe]

When you go to page setup and pick what you want does it still show the preview incorrectly?
I've had no end of problems printing. I must be the worlds worst person for wasting paper.
Is this on old drawings? Or new drawings you have recently created?
There is a way you can create page setups and import them in at the begining of your drawing by going to plot then where it states 'page setup name ' click to add.
Not sure if this helps,
but have a merry christmas anyway.

Page setup is definatly the problem. Just correct it and it should be fine.

[DoYouKnowMe]

Did you happen to plot from the pspace to either another plotter/printer and do a window of a selcted area? That has the possibility of being the culprit.