Jump to content

how to know what unit of measurement I'm using?


13tildawn

Recommended Posts

Hi Dadgad, Please find attached image.

 

I composed a lengthy response yesterday, but when I tried to send it, the site was down.

It looks like the tiles in your drawing are meant to be 80cm x 80cm.

 

Measure the length of one of the tiles using your osnaps, then scale it accordingly, so that with your -dwgunits set to mms, it measures 800mm.

Did you ever try running the -DWGUNITS command, as I suggested in my earlier post?

 

It would be much easier to help you if you could upload part of this drawing (the .dwg file).

You can strip out the titleblock, and any proprietary information, and most of the drawing too,

if it is bigger than what is shown.

Once you do that it should be easy to resolve.

Link to comment
Share on other sites

  • Replies 22
  • Created
  • Last Reply

Top Posters In This Topic

  • 13tildawn

    4

  • Dadgad

    4

  • Rizalyn

    4

  • azzro10

    3

Top Posters In This Topic

Posted Images

I started reading this thread from page 1 and was thinking of a reply when I noticed the dates.

 

Holy thread necromancy, Batman!

 

Yeah, it was exhumed on the 8th of September, THIS year. :)

 

You might want to rethink your thread display preferences.

I have mine set so that the newest display at the top of the page. :beer:

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...