fostertom Posted August 11, 2008 Share Posted August 11, 2008 xline>ang - why in this file is the entered angle now being counted from the vertical axis instead of the horizontal? Quote Link to comment Share on other sites More sharing options...
ReMark Posted August 11, 2008 Share Posted August 11, 2008 Am I missing something or did you not attach the file? You are aware that the Xline command gives the user the options Hor/Ver/Ang/Bisect/Offset? Quote Link to comment Share on other sites More sharing options...
fostertom Posted August 11, 2008 Author Share Posted August 11, 2008 No, there's no attachment - 'this' file is the one I'm working on. Yes I know those options - it's about the Ang one and from which axis, vert or horiz, it counts the angle I enter. Quote Link to comment Share on other sites More sharing options...
Dipali Posted August 11, 2008 Share Posted August 11, 2008 It happened in one of my file earlier, & after investigating I realised that file was wblocked out of the drawing in which I was working on ucs which was not the world but perpendicular to world Quote Link to comment Share on other sites More sharing options...
chulse Posted August 11, 2008 Share Posted August 11, 2008 That would be dependednt on the Direction Control settings under UNITS I think... Quote Link to comment Share on other sites More sharing options...
fostertom Posted August 11, 2008 Author Share Posted August 11, 2008 That's it chulse, brilliant Quote Link to comment Share on other sites More sharing options...
chulse Posted August 12, 2008 Share Posted August 12, 2008 That's it chulse, brilliant Woohoo I got one right! Glad to help Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.