Jump to content

Object Snaps on MEP Objects


Snowman

Recommended Posts

I am unable to get the object snaps in MEP 2009 to select the corner of a structural member like you could in MEP 2008.

 

What is the variable to turn this back on?

Link to comment
Share on other sites

  • 2 years later...

I have the exact same question posted. I have seen it done on a co-workers computer, so I know it in there somewhere. I just think it has something to do with the Profiles and WorkSpaces, perhaps. I haven't worked with this one long enough to figure it out yet. The standard O-snap menu features "MEP snaps", but they are very unspecific.

Link to comment
Share on other sites

  • 1 month later...

I do not know about MEP, but in Architecture there is a setting for this in OPTIONS under AEC Editor.

 

From help section: "Under Optimize for Speed, select Object Snap to limit certain display representations to respond only to the Node and Insert object snaps.

This setting affects stair, railing, space boundary, multi-view block, masking block, slice, and clip volume result (building section) objects"

 

So what it says is that If the box is ticked, it doesnt snap to anything else then the insert point of ex. multi-view block.

 

//Tobias

 

 

Object snap.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...