ralph Posted September 9, 2008 Share Posted September 9, 2008 Working on some drawing for a tender and I like to make the drawings not so engineering like and have curved leaders Was on another project contracting a few months ago and they had it set up so the leaders were like splines Any one know how I could go about this? cheers:) Quote Link to comment Share on other sites More sharing options...
bonehead411 Posted September 9, 2008 Share Posted September 9, 2008 Start the leader command, then before choosing your first point just right click or hit enter to bring up the leader settings box. On the leader line & arrow tab, check the spline radio button. Quote Link to comment Share on other sites More sharing options...
BenE Posted September 10, 2008 Share Posted September 10, 2008 You also have the option of changing your multileader style with MLEADERSTYLE. Within that box, you can set up a spline leader, as well as change the style of your text, arrowhead, spacing, etc. -Ben Quote Link to comment Share on other sites More sharing options...
Bogbadbob658 Posted September 14, 2008 Share Posted September 14, 2008 Start the leader command, then before choosing your first point just right click or hit enter to bring up the leader settings box. On the leader line & arrow tab, check the spline radio button. You can also increase the number of points creating the spline by adjusting the 'maxpoints' option. Quote Link to comment Share on other sites More sharing options...
NaeKid Posted September 18, 2008 Share Posted September 18, 2008 Thanks for sharing this .. I didn't realize that you could change the styles outside of the properties-control-box.. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.