Jump to content

Creating Blocks on the Fly


mcguirepm

Recommended Posts

I have a VBA program that creates 3D blocks on the fly. The blocks are attributed, but now I want to add data to the blocks so that we can start using the BOM feature in AcadMech 2008.

 

The kicker here is I need to figure whether to use Mechanical Structures or Part References.

 

Which one can be seen by the BOM through Xrefs?

 

Lastly, can someone tell me how to make this proper type of data part of a block.

 

Thanks in advance.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...