Jump to content

never ending trim


michaeloureiro

Recommended Posts

Hello,

 

I´ve just found myself with a the pain staking task of triming an infinite number of lines inbetween two parallel ones.

 

Is there an easier way to do this?

 

thanks.

Link to comment
Share on other sites

are you trying to pick each in turn? If so having selected your trim edges, click above your first line to be trimed, then drag lightly left and down and click below your last item to be trimmed. AutoCAD isn't very good if you pan during your selection so if the parallel lines are far enough apart it is best to do this with everything on the screen.

Link to comment
Share on other sites

dbroada,

 

that´s the problem, the lines are too big to cross select everthing,

if there was a way to just select the two lines and trim everthing inside...

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...