Fillet Problem

Hello there everyone.

I have been asked to draw a rectangle that is 1 wide by 3 unit tall with the bottom left corner at .75, .75

and use fillet to make the corners of the rectangle round, with the radius of .375

What i have assumed to do is the following:

COMMAND: rec

First point: .75,.75

other point: 1,3

Command: f

r: .375

and selected left side of the rectange, and the top line

Now the problem is, it wouldnt work.

Thanks in advance

other point: @1,3

if you follow this sequence you can fillet all corners at once.

Command: fillet

Current settings: Mode = TRIM, Radius = 0.3750

Select first object or [undo/Polyline/Radius/Trim/Multiple]: r

Specify fillet radius : .375

Select first object or [undo/Polyline/Radius/Trim/Multiple]: p

Select 2D polyline:

4 lines were filleted

because if you start at .75,.75 and end at 1,3 then your total size is only .25x2.25.....start at .75,.75, make your other point 1.75,3.75...then fillet...i tried it and it will work....

you can do it exactly as you did it before just make the last point 1.75,3.75

Cheers lpseifert, and hotrodz0321. It worked yay! For some reason, i didnt think of it that way. Cheers again.