Jump to content

Attribute text in blocks


Recommended Posts

Hi,

I have a block with attributes in it.

 

The position of the attribute text is not locked so after inserting the block I can move this text to a more readable position.

 

My problem is that when I edit the block by adding a new attribute, I save the changes, and then use attsync in my drawing where the blocks are, the attribute text that I have already positioned goes back to where it was originally leaving me having to repostion all the text again.

 

Is this avoidable??

Link to comment
Share on other sites

Personally i would put a move parameter on the attribute rather than unlocking it. That should do the trick.

 

oops sorry your on civil 3D not sure you can do that SORRY

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...