Jump to content

Haloed Lines


kwortman

Recommended Posts

I have a question about the display of haloed lines. I am using ABS2006.

 

I am using a 10” Dia Round duct slip joint US imperial duct at 12’ elevation.

I have a 24” x 24” square louver face ceiling diffuser-10” neck at 8’ elevation

I am connecting the two with a 10” Dia round corrugated flex duct slip joint US imperial flex duct at 12’ elevation.

 

The haloed lines show up correctly when the 24x24 diffuser in underneath the regular duct but the haloed lines only show up at the connector when the diffuser is underneath the flex duct. Are the haloed lines supposed to show up underneath flex duct or am I just beating my head against the wall.:?

Link to comment
Share on other sites

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...