Tostrhed Posted October 17, 2008 Share Posted October 17, 2008 I'm totally new to AutoCad LT, been using TurboCad. Just doing 2 dimension layouts.. Usually i represent a 2 in beam by a double line with a 2 inch seperation.. I cant find a double line in AC. Also, how do i change the grid scale.. usually my grid is 6" x 6" squares.. in AC when i make a long line, i cant zoom out enough to see the end.. Thanks! Tom Quote Link to comment Share on other sites More sharing options...
BOB'27T Posted October 17, 2008 Share Posted October 17, 2008 Use the MULTILINE feature. Quote Link to comment Share on other sites More sharing options...
Tostrhed Posted October 17, 2008 Author Share Posted October 17, 2008 When i enter MLINE it doenst recognize the command, and theres no symbol for it , only one for LINE Does it matter that this is LT ? Quote Link to comment Share on other sites More sharing options...
ReMark Posted October 17, 2008 Share Posted October 17, 2008 I don't believe the multiline command MLINE is part of the feature set of LT. Quote Link to comment Share on other sites More sharing options...
Nick Rennie Posted October 19, 2008 Share Posted October 19, 2008 Yup, no MLINE in LT. From memory in LT you can use a similar command, DLINE. Quote Link to comment Share on other sites More sharing options...
Tostrhed Posted October 19, 2008 Author Share Posted October 19, 2008 Thanks Nick! Dline works. I even figured out how to add it to the ribbon panel. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.