MTS Posted October 24, 2008 Share Posted October 24, 2008 I am looking for a way of creating a line type that creates a line with two parallel lines with a poly line type fill between them. It often used for trunking in the electrical industry. Not a good way of describing it i suppose its like a wide dashed line with inside double line Quote Link to comment Share on other sites More sharing options...
ReMark Posted October 24, 2008 Share Posted October 24, 2008 Have you looked into the Make Linetype command in Express Tools? Quote Link to comment Share on other sites More sharing options...
MTS Posted October 24, 2008 Author Share Posted October 24, 2008 Not yet but I will have a look, suppose I was looking for a amore complex solution! Quote Link to comment Share on other sites More sharing options...
ReMark Posted October 24, 2008 Share Posted October 24, 2008 Then take a look at my thread "Options for creating custom linetypes" in the AutoCAD forum. There's a piece of software mentioned that can assist in the creation of complex linetypes. Obviously there is a cost involved so you would have to determine whether you have enough future need for this type of program. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.