Jump to content

Dimension - remove dimension line but not arrows


jkristia

Recommended Posts

I think I have tried every single option in properties, but I still can't figure out how to remove the dimension line between the arrows on the dimension indicating the diameter.

 

Any suggestions ?

 

Thanks

Jesper

dim.jpg

Link to comment
Share on other sites

Alternatively, create an arrow as a block and use the dimension line suppression as mentioned above- there should still be nodes on the extension lines you can snap to.

Link to comment
Share on other sites

>>As a very last resort, you could explode the dimension

>>Alternatively, create an arrow as a block and use the dimension line suppression

 

Both good suggestions which I didn't think of.

 

Thanks

Link to comment
Share on other sites

>>As a very last resort, you could explode the dimension

>>Alternatively, create an arrow as a block and use the dimension line suppression

 

Both good suggestions which I didn't think of.

 

Thanks

You don't need to go to that trouble. Under 'Fine Tuning' in the fit tab, choose 'Place text manually' and deselct 'Draw dim line between ext lines'. Make sure 'arrows' is selected on the left hand side under 'fit options'. You probably need to do this as an override as you probably don't want it for all your dimensions. Hope it helps....

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...