Bruce G Jackson Posted November 12, 2008 Share Posted November 12, 2008 My apologies in advance for bringing this up again...... I've spent the last 60 minutes searching and still haven't come up with an answer. I'm working on a drawing that was done in imperial. That is to say, if I do a "dist" command on a door opening I get a measurement of 3'-0" I understand the concept of units, but is it possible to change the output of the "dist" command to read millimeters instead of feet and inches? Thanks, for your help. Bruce. Quote Link to comment Share on other sites More sharing options...
nocturne00 Posted November 12, 2008 Share Posted November 12, 2008 Use UNITS command to set it. change architectural to decimal. Quote Link to comment Share on other sites More sharing options...
Bruce G Jackson Posted November 12, 2008 Author Share Posted November 12, 2008 Now that was easy Thanks Nocturne. Quote Link to comment Share on other sites More sharing options...
dbroada Posted November 12, 2008 Share Posted November 12, 2008 although that wont do the conversion to metric, it will still give you the imperial distance in units. Quote Link to comment Share on other sites More sharing options...
nocturne00 Posted November 12, 2008 Share Posted November 12, 2008 Now that was easy Thanks Nocturne. Glad to help. Cheers Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.