Jump to content

Assembly parts don't behave as solid


paulkennethkent

Recommended Posts

Hey everyone,

 

I need some help with my assembly! I have made a small safe using a few parts! I can "mate" everything fine but what when i try and close the door of the safe, the door itself goes through the solid material! i want to be able to give it some degree of freedom (open and close the door) but not so it goes through another "part" Please help! if you ask, i will upload the parts and the assembly.

 

Thanks

Paul

Link to comment
Share on other sites

what version of SW are you using. You can add to your constraint an amount of rotation you wish it to have(90degrees or so). i believe you can also(in the options) constrain it to stop on contact. If you are using 08 or 09(only two ive worked with) when you are adding your mates, there is another tab that says motion. i cant get you a screen shot until tomorrow.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...