Jump to content

Join wall with floor


Hmm..

Recommended Posts

Hello everyone!

 

I'm trying to join the wall with the floor that has thickness 200mm. I have modified the wall sketch so there is a cutout 100mm you can see it in picture 1. So far everything is just great. Now i go to the section (picture 2) and the foundation wall and floor intersects, and after using join function everything looks very good (picture 3), but when I go back to 3d i can see that foundation wall is attached or trimmed to bottom of floor, which I don't need (picture 4). Have anyone had such case? Is it possible to create it right otherwise there can be bad mistakes in the project, because while looking in the section everything is ok, but when placing spot dimensions, then the fun begins.

Joining function2.JPG

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...