Jump to content

Labeling Problem


Astr8upfella

Recommended Posts

Hey everyone. I'm using LDD Civil 2000i...I know...My boss is a tightwad and hasn't upgraded us yet. Anyway, I'm designing a storm sewer. I calculated the slopes myself and entered everything into the computer. I want a constant slope of 0.5%. Everything looks good on the table where you enter all your data into. Then I generate the profile and the slopes are 0.4, 0.37, 0.7...what gives. I can't figure it out. Any help would be great. Thanks.

Link to comment
Share on other sites

Thanks for the reply. Yes, that is the weird part. I go right back to the table and they all say 0.5%, but in the profile they're all different.

Link to comment
Share on other sites

Are only the labels wrong or is the linework coming in at the other slopes as well?

 

I don't even have Land loaded anymore so I can't do much to help. You could try to run a new profile and see if the problem persists.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...