Jump to content

What up with this leader arrow...!?


flem snopes

Recommended Posts

I'm in AutoCad 2009 block editor trying to modify a leader in the properties box.

 

I've got 4 leaders in the block and only one of them is acting squirrely.

 

The Misc. block has a type property with 4 choices as follows:

 

Line with no arrow

Spline with no arrow

Line with arrow

Spline with arrow

 

It's currently showing Line with no arrow, I want a line with an arrow.

I select Line with arrow and when I tab out of the box it reverts to Line with no arrow.

 

The other 3 leaders are acting normally.

 

Any suggestions?

Link to comment
Share on other sites

  • 5 years later...

Its usually a dimscale vs ltscale issue. Often the dimscale gets reset to some value that is big, or small enough that while the arrows are appearing they're usually too big or small to appear. Try playing around with dimscale in wherever you place leader lines (paper or model space)....you'll eventually get the arrows to appear.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...