Jump to content

2D Assembly drawings in Inventor


kng

Recommended Posts

I created an assembly in inventor and THEN cut holes in it. Is there a way to either make drawings of the individual parts in the assembly (with the holes) or to incorporate these holes into the original parts?

 

Thanks for the help.

Link to comment
Share on other sites

Inventor works like the real world - assembly level machining occurs after parts are put together (ie match machined holes).

 

Assuming you want to avoid going back and doing it the right way you could create multiple drawings of the assembly and suppress those parts that you don't want to see in each drawing. The result will be a drawing of each individual part as machined.

 

You should have posted this question in the Inventor area of this site.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...