Jump to content

Insertion point moving after using look up table


feargt

Recommended Posts

Can anyone tell me what I'm doing wrong here or why this is happening, please see attached DB block.

 

When I use the look up table to specify a distance of a line I want the rest of the block to scale relative to this distannce. it works once or maybe twice but then the insertion point starts moving......

 

Any ideas?

ELBOW.dwg

Link to comment
Share on other sites

The problem is that you are moving your arcs, but the base point of the scale action isn't moving, I'll try to work it over when I get a chance.

Link to comment
Share on other sites

Thanks, I was of the opinion that the scale action would work from the centrepoint of the line as the Linear paramter is set to midpoint

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...