feargt Posted January 19, 2009 Share Posted January 19, 2009 Can anyone tell me what I'm doing wrong here or why this is happening, please see attached DB block. When I use the look up table to specify a distance of a line I want the rest of the block to scale relative to this distannce. it works once or maybe twice but then the insertion point starts moving...... Any ideas? ELBOW.dwg Quote Link to comment Share on other sites More sharing options...
MaxwellEdison Posted January 19, 2009 Share Posted January 19, 2009 The problem is that you are moving your arcs, but the base point of the scale action isn't moving, I'll try to work it over when I get a chance. Quote Link to comment Share on other sites More sharing options...
feargt Posted January 19, 2009 Author Share Posted January 19, 2009 Thanks, I was of the opinion that the scale action would work from the centrepoint of the line as the Linear paramter is set to midpoint Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.