kwortman Posted February 3, 2009 Share Posted February 3, 2009 I did a search for this and could not find any posts. I am using ADT2006 and when I create a callout (Boundary, Section, Elevation, etc.) it takes 3 to 5 minutes to generate, in a new drawing. Is there some way to get the callout to generate quicker? I tried this in two basic templates (acad.dwt & AEC Model imperial.dwt) and they both took the same amount of time. Is this just an issue with 2006? Thanks in advance. Quote Link to comment Share on other sites More sharing options...
Jonny_B Posted February 3, 2009 Share Posted February 3, 2009 I did a search for this and could not find any posts. I am using ADT2006 and when I create a callout (Boundary, Section, Elevation, etc.) it takes 3 to 5 minutes to generate, in a new drawing. Is there some way to get the callout to generate quicker? I tried this in two basic templates (acad.dwt & AEC Model imperial.dwt) and they both took the same amount of time. Is this just an issue with 2006? Thanks in advance. what kind of grunt does your machine have, and how complex is the drawing? i have a new machine and an elevation of a small house (2000 s.f.) takes a very reasonable amount of time to generate (well under a minute) but that's sort of the best case scenario. Quote Link to comment Share on other sites More sharing options...
Noahma Posted February 4, 2009 Share Posted February 4, 2009 how big is your building? I have some very small homes that take 10 seconds to do a section or elevation, and then some more complex large homes that can take quite a bit longer. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.