joffy Posted February 19, 2009 Share Posted February 19, 2009 I am trying to draw a rectangle in paperspace per setting up procedures. I have created a new sheet, set it as current and draw a new rectangle with the following points 0,0 - 297,210. The new rectang now goes off the "whitespace". Why is this? The page setup is set for A4. Quote Link to comment Share on other sites More sharing options...
Hedgehog Posted February 19, 2009 Share Posted February 19, 2009 If it's only just going off the printable area then it's because most printers don't print right to the extents of the media they're printing to... you have to offset your border by say 5mm (or measure it on the screen) to get into the printable area. If it's completely off then you need to look at your page setup (landscape/portrait?). Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.