Jump to content

double line duct work with eccentric reducer


cadmando2

Recommended Posts

I have been having some good luck with being under the gun trying to get work out with dead lines and have two many project due it not funny. We have 5 projects due and not enough time to get them done. The existing stuff has been done thanks for “Lee Mac’s” help.

That’s Lee, couldn’t had done it without you bubby. Now the “new” work we need to show double line duct work and there need to have Eccentric Reducer.

Flat on one side and reducer on the other side. But it would be nice to select witch side the flat side in on. We got 3 days to complete just one project?

Now I need a double line ductwork that has Eccentric Reducer?

Is there any lisp routines out there.

 

Link to comment
Share on other sites

Sorry Lee,

I had not had time to try the Double line ductwork with Eccentric Reducer. It was crazy around here trying to make are dead line and not having time to try the lisp routine out. I have a little time to day to try it out. This looks like a pipe lisp routine? Thanks again

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...