1,000,000 seperate points to a surface- can it happen

i have a file that has a million (literally one million) points and i need to make a solid part out of this.

we had a radome (nose cone of an airplane) laser scanned, now i need to make a solid so that i can make a tool. but i am stuck i don't know how to get from the points to a solid. i have done smaller parts before with about 500 points but they were simpler parts that i could take a couple areas and make a pline and them loft them together but that just isnt possible for this one

does anyone have any ideas

ps i have autocad 2008 and inventor 08

i have a file that has a million (literally one million) points and i need to make a solid part out of this.

we had a radome (nose cone of an airplane) laser scanned, now i need to make a solid so that i can make a tool. but i am stuck i don't know how to get from the points to a solid. i have done smaller parts before with about 500 points but they were simpler parts that i could take a couple areas and make a pline and them loft them together but that just isnt possible for this one

 

does anyone have any ideas

ps i have autocad 2008 and inventor 08

Is this made out of polylines? A picture would be helpful.

there are no lines the only data in the drawing is "points" here is a couple of pictures the bottom one is a zoomed in view

See here: http://www.sycode.com/products/point_cloud/index.htm

It is not free, but it has a trial period -just enough for one job.