Jump to content

How Change Line Length Depend On Attribute Value Change


MR MAN

Recommended Posts

lots of ways to do this, some more complicated than others. You need a reactor either way I think. Thinking out loud, from VBA, using end command, watch for ddatte or eatte, then check block value, grab att, find line based on handle or some other method, adjust length

Link to comment
Share on other sites

Just throwing this out there: could there be a way to set up a dynamic block to do this?

 

In any case, I'm in for the reactor. ;)

Link to comment
Share on other sites

Thinking outside the square back a few years ago was the "Shaft" demo (supportfiles) for the excel to acad link you could change the excel value and the drawing changed this may help with an answer.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...