Jump to content

How to find intersection with extrude?


Recommended Posts

This is a 3d isometric drawing, and I'm extruding the circles along the X axis, but I can't figure out how to draw that one line.

 

 

Anyone have any ideas? extrude.jpg

Link to comment
Share on other sites

Model like you would machine the actual part - drill the holes last.

Extrude the Ø2.250 circle to 1.594 - the center of the part. Then Union.

After you have the entire solid then drill (presspull) the holes.

Link to comment
Share on other sites

Model like you would machine the actual part - drill the holes last.

Extrude the Ø2.250 circle to 1.594 - the center of the part. Then Union.

After you have the entire solid then drill (presspull) the holes.

Since you have already extruded the circle by a certain height, try offset face (solidedit).

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...